Hey,
Taking the vertical head off of my MH300 and putting it back on feels like it's requiring more effort than it should - the head sits on the alignment pins extremely tight.
Do these pins have any kind of adjustment? Or do you know how to remove these if I'd like to check the fit?
Hey,
I recently purchased MAHO 300 which was unfortunately stripped of factory pancake motor drive (BBC LE 10 b-E). Currently it is equipped with simple DC driver that does not take tacho readings into account (and tops up at ~58V, so quite slow).
I'm looking for an electrical diagram of the original system, especially anything related power feed, how it was connected originally.
What will be also super useful, if anyone has similar machine at hand, is to measure the voltage that the motor receives while running rapids (measured across A and B terminals) and tacho reading at rapids also (between T+ and T-).
Machine photo for reference:
Thanks!
