Hi Guys,
Ifinaly managed to startup my mashine. With some minor issues đ
Mashine starts up and all axis working in manual mode. Z axis tripping on Z-09 dymamic following eror. I can jog it manualy in 20% feed rate, otherwise it tripps out. Refference function starts and tripps mashone on following eror.
X axis couol be refferensed with no issues.
Y working in jog mode, but no movment in refference mode.
Oerator pannel TEACH button did not function. Temporerary fixed while I decide purchase new pannel or upgrade this one to different push buttons. At a mean time "tool mag." button will be assigned to "teach" đ
Wile button is working, the teach function is not.
I'm not sure if it is active only after all axys are refferenced?
So I cant test the spindle.